![]() Choose a location with a clear line of sight, with no obstacles or blind spots.Install in a corner or on a flat wall (see illustrations).Install 2.3 metres above the floor, if possible.Where should you place your Motion Detector? ![]() In Test Mode, motion is constantly detected, and when motion stops, it will clear every few seconds. By adjusting Motion Detector settings in the app, you can set the device to ignore your pets and only detect humans, or to detect everything. Test Mode is designed to help you test for blind spots, pets, and other environmental triggers that can trigger false alarms. By default, when armed in Away mode, motion will set off the alarm. Ring Alarm Motion Detectors are designed to detect intruders by monitoring your spaces for changes in heat and movement over time. ![]() If you need to arm your Alarm while a Sensor is in this "tampered" state, you will be prompted to bypass it to continue arming. It will return to normal once you slide the cover back on. When you slide the battery cover off of a Contact Sensor to change the batteries, it will show as “tampered” in the Ring app. If the magnet is too large, open the back and remove the magnet piece from the magnet case and mount it directly. Peel the backing from the attached tape and press the sensor and magnet into place for 30 seconds. If installing it on a door, choose a side without hinges (see image). Line them up with no more than 2.5cm (1") between them (see image).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |